KEENCUT
Sabre & Sabre Series 2 lift arm
Single steel lifting arm to suit either end of Sabre or Sabre Series 2.
You Must be Logged in to Add the Item to your Cart.
Description
How to replace the lift arm on the Sabre & Sabre Series 2
Tools required:
Posi screwdriver
Allen (hex) key 4mm
8mm Spanner (wrench) or socket
Brush/cloth for cleaning
Silicon spray lubricant or lithium grease
What to do
Remove the end cover by undoing the three fixing screws using a Posi screwdriver
Remove the two screws fixing the lift arm to the main cutter bar using an 8mm spanner (wrench)
Remove the hinge screw using a 4mm Allen (hex) key, clean the plastic bush and washer with a dry cloth, do not use solvents. There may be white PTFE (plumbers) tape around the hinge screw leave this in place or replace if in bad condition. Wind enough on so plastic bush is a tight fit on the screw.