Fedrigoni 12yr Gloss Wrap

Fedrigoni Ri-Jet C50 Ultimate Slide and Tack with Ri-Lam C30

This 12-Year CAST film is the ideal solution for Customizing or Branding any
type of vehicle or commercial fleet. Easily conformable on any 3D surface.

Unique Feature;

• Factory “Pre-Stretched” 12-Year Cast Film.
  • This design builds in a small amount of surface tension allowing the installer to work less when applying resulting in faster installations.
  • Why? because our factory pre-stretching conforms almost by itself. Simply apply heat and allow it to cool (notice the film self-conforming). Then apply effortlessly for bubble free application to any 3D
  • Once the vehicle is fully wrapped heat the film to 113 Fahrenheit to fully set the long-term bonds.
  • Ultimate Slide and Tack; Our special adhesive formulation, surface tension design, combined with our proprietary microstructure liner, are revolutionizing installation techniques.
  • The low initial adhesion of the adhesive means that the film can be easily repositioned on any surface over a longer period. Ultimately providing multiple adjustments while easily eliminating any trapped air.

Highly Conformable; 

• The high quality of the PVC guarantees optimal application on the most complex surfaces that require a highly conformable and adaptable material for the best finish.
• This ensures high dimensional stability over the life of the application.For use with any printing technology The Ri-Jet C50 is particularly suitable for digital printing, thanks to the structure of its material, Compatible with Eco-Solvent, Latex, UV-Cure, UV-Gel and Resin platforms.

Application Instructions;

• Allow a minimum of 24-48 hours for ink to dry before application of the overlaminate, or to the vehicle.
• Depending on the print and drying conditions, this can often be in excess of 48 hours. Retained solvents will reduce adhesion levels.
• To achieve the best possible print quality, make sure that the correct ICC profiles or printer settings are used.
• Successful vehicle wrap application requires the necessary techniques.
• The printed vinyl must be laminated with Ri-Lam C30 Ultimate Laminate to protect the printed image from UV fading and mechanical abrasion.
• Do not overstretch as this will cause the application to fail.
• Only suitable for dry application on clean and degreased surfaces at temperature above 15*C, ideally at 20*C. The vinyl needs to be heated at 35-40*C before being conformed to 3D areas.
• During application onto these 3D areas, considerable tension will be introduced in the material which is essential to release. This tension will be released by post-heating the material to 90*C. Without this stabilization, the vinyl may pop out of the recesses later.
• Adhesion build-up curve is low under 15*C. In wintertime, the wrapped car needs to remain inside premises at 20*C for 24 hours. If the car needs to be released outside earlier, we recommend first warm-up all film surfaces to 25-30*C before moving the car outside.
• Once the wrap install is complete, it is highly recommended to post-heat to 90*C (190*F), especially on the edges and in curves and recesses, to promote final adhesion.
• The user should determine the suitability of the substrate.